Acme L47-2 Twin Head Centerless Finishing Machine w/ vibratory feed table

(2) Belt Finishing Head Assemblies:
Rubber Covered Contact Wheel................. 4" Face, 8" Diameter
Grit Impregnated Regulating Wheel............ 4" Face, 6" Diameter
Belt Drive................................... 5HP 480V 60HZ 3PH 1750RPM TEFC Motor
Speed........................................ 5000 SFPM

Cast Iron Head, Regulating Wheel, and Work-rest Assemblies
Pneumatic Belt Tensioning Assemblies with Hand Valve and FRL unit
Heavy Steel Fabricated Weldment Base to Accommodate (2) Finishing Head Assemblies

The units are controlled making use of;

Cast Iron Belt Tensioning Idler Wheel - 4" Face, 4.25" Diameter
Regulating Wheel Drives, 1/2hp DC Motors with Variable Speed Controller for up to 125RPM
Feed Rate Adjustable from 0-35 feet per minute (Depending on helix angle)
Abrasive Belt Size - 4" wide, 84" long
Workpiece size capacity of 3/32" min to 2 2/3" max diameter
Thru-feed Rest Blade assemblies adjustable via a coupled threaded shaft and hand wheel to accommodate different diameter parts.
Adjusted heat-treated and ground precision side guides
Integrated coolant system 130gal capacity, Centrifugal Coolant Pump
Complete electrical controls and wiring for 480/60/3ph with 110V control circuit, including fused disconnect switch and separate operators push button control panel

Floorspace Requirement - 60" x 55" x 6'